Wilco OffroadSKU: UHG32130

Size: Standard
Add: No


When it comes to strength and weight, the Hitchgate™ Solo packs a powerful punch. With the same tow rating as its bigger siblings and the capacity to carry a 35-inch tire (on a mid-sized truck), the Solo is ready for whatever the adventure calls for. The Hitchgate Solo was designed to go lean and low on the next adventure while still being prepared. The Hitchgate Solo’s reduced weight is perfect for those looking to carry a 35-inch  (on a mid-size vehicle) or smaller spare tire, and Rotopax fuel cans.

Not only is weight reduced, but so is the overall height of the horizontal support arm which sits 4″ lower than a Hitchgate Classic or MAX. By relocating the truck mount at the *same level* as the vehicle’s receiver hitch, the Solo is uniquely designed to accommodate vehicles that have a tight clearance between the rear hatch/door and the receiver (Ex: Sprinter, Renegade, Tahoe, Grand Cherokee). The Hitchgate Solo is also a phenomenal candidate for Subaru (see Fitment section below) and any vehicle where every pound counts. 

The Hitchgate Solo spare tire carrier universally fits on almost all vehicles with a Class III/2″ hitch receiver. This swing-away, spare tire carrier mounts to any 2-inch, Class III hitch receiver and is perfect for SUVs, Jeeps, vans and pickups. This tough tire carrier secures up to a 35-inch spare tire (on mid-sized vehicles) while maintaining ground clearance with minimal change in departure angles when driving off-road. Release a single latch pin and it opens wide for full access to the vehicle’s cargo space. The Hitchgate Solo line  is tow-rated at 7,500 lbs (max trailer weight) and 750 lbs (tongue weight). *These limits may be more than your vehicle’s capacity. ALWAYS stay within the limits of your vehicles tow/tongue ratings)* The tire carrier is rated for 150lbs of total weight. If your tire and wheel reach that limit, you won’t be able to carry any fuel or tools…look towards the Hitchgate Classic or Max for more capacity.

Swinging Hitch Option:

Need to swing a bike rack, or hitch mounted cargo basket out with your Tire? The Hitchgate now has an optional secondary swinging hitch to allow just that. The Solo will still come with a standard stationary receiver designated for towing.

***Bike rack may require hitch extension depending on tire width and bike rack’s tongue length.***

3 Solo Models to choose from:

  • Hitchgate Solo Standard UHG32130 sits at hitch height and is 25″ wide on the support arm. If your hitch is near your rear hatch, probably a good choice.
  • Hitchgate Solo *High Clearance*  UHG33187 is a Solo Standard with the horizontal support arm moved 4″ higher. If your hitch is under your bumper/body, probably a good choice.
  • Hitchgate SoloXL UHG32206 is a mirror image of the Solo but is 5″ wider. This allows full-size trucks to carry up to a 35″ tire + and allows full-size vans to open their doors past 90 degrees.


  • Rotopax® fuel can/Hi-lift jack Mount RPHL32453 *Rotopax gear not included*
  • 48″ All-Cast Hi-Lift Jack HLJ0485 
  • Dual Rotopax Mounting kit (for vehicles with a tight fit between vehicle and Solo carrier)
  • Solo License Plate Relocation Bracket LPR32204 *light not included*
  • LED License Plate Light LPL1468
  • Master Lock Locking Hitch Pin 1480DAT
  • Master Lock Locking Hitch Pin Extended Length 1469DAT (recommended for 2.5″ hitches and Tacoma/Tundra)
  • 2.5″ Hitch Adapter 32190 (Allows functioning wedgelock in a 2.5″ hitch)
  • Wobble Free Hitch Extension HE31973


  • Solo Standard–> 53lbs Almost all compact and mid-sized trucks, SUVs and cars with tires up to 35″. Full sized trucks, SUVs and cars with tires smaller than 33″.  [25″ wide from hitch to pivot bolt, 3.5″ minimum depth from 1st hitch pin to back of support arm. 4.5″ to the next hitch pin hole. Solo sits at hitch height, rising only 2.5″ above the receiver.]
  • Solo High Clearance–> 54lbs Almost all compact and mid-sized trucks, SUVs and cars with tires up to 35″. Full sized trucks, SUVs and cars with tires smaller than 33″. [25″ wide from hitch to pivot bolt, 3.5″ minimum depth from 1st hitch pin to back of support arm. 4.5″ to the next hitch pin hole. Solo High Clearance sits 4″ above hitch height, rising 6.5″ above the receiver.]
  • SoloXL–> 56lbs Full sized trucks, SUVs and cars with tires larger than 35″ OR those who need the tire to swing further away from the vehicle. [ 30″ wide from hitch to pivot bolt, 3.5″ minimum depth from 1st hitch pin to back of support arm. 4.5″ to the next hitch pin hole. SoloXL sits at hitch height, rising only 2.5″ above the receiver.]
  • Fitment Calculator–> Multiply the width of the Solo arm you’re interest x2, then subtract half the diameter of your tire…the sum will give you an estimate how far away your tire will sit from your hitch and help you choose the Solo that’s right for your. Solo Standard = 25″, Solo High Clearance = 25″, SoloXL = 30″


  • Zero offset or shallow offset (high positive offset) wheels may require an additional wheel spacer.
  • When properly installed, the Solo will sit level with inside of the hitch…if your bumpers arc upward at the corners, the Solo may appear not to follow those body lines as it is mated up to the hitch rather than the bumper. This is not a warranty situation.
  • Solo WILL interfere with factory back-up sensors and/or back-up camera. The camera will still have *some* visibility through your wheel and the ground below.
  • 4.5″ of clearance is required from center of hitch pin hole rearward for it to be compliant with wedge-lock system. You may need to relocate spare tire from underneath or modify to gain the necessary clearance.
  • SUBARU OWNERS: Due to the small hub diameter, some models will require a hole drilled into the wheel plate to allow for a 3rd Lug Bolt to be installed
  • SUBARU CROSSTREK: If you’re planning on using a Torklift Eco Invisi Hitch, the Solo will *not* work with the stock exhaust system AND body trimming may be required to gain access to hitch pin holes.
  • SPRINTER VANS WITH DUALLY REAR AXLES: You will need to purchase a wheel adapter plate. Call to order.
  • VEHICLES WITH CLAMSHELL REAR DOORS(LAND CRUISERS, LEXUS LX SERIES, ETC): The Hitchgate Solo High-Clearance DOES NOT work with these vehicles. The lower tailgate portion will come in contact with the base of the Hitchgate due to the low distance between the hitch and tailgate. We recommend the Hitchgate Solo XL, but we highly recommend double checking your measurements before ordering, or feel free to give us a call and we are happy to help.

Like all Wilco Offroad products, the Hitchgate Solo is proudly built in Southern California and comes with a limited lifetime warranty.

Solo Installation Instructions now available on the Bilt App.

Click here to view Hitchgate Solo Guide




Payment & Security

Amazon American Express Apple Pay Diners Club Discover Meta Pay Google Pay Mastercard PayPal Shop Pay Venmo Visa

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

You may also like

Recently viewed